Honeywell alarm keypad wired zone professional#

I even went as far as to remove the envisalink 4 and change all programming back to previous state and still.missing expander. Then all was well for a moment until i started getting the missing expander and each zone on the expander. I redid the programming to the 'updated' honeywell directions and not what was listed on the web site. I had gone from still seeing everything on my V15P after envisalink installation, but having an error with the envisalink that programming wasn't complete. Is there any specific programming errors that you can think of that would lead to zone expander error? As I have exhausted the wiring checks at either end. Good luck and I'd be interested in hearing if this fixed your issue.

That's all that I can offer from my layman's perspective. which would indicate they are 'Not Used'. You may also want to check in the Zone Programming Field (*56 on the Vista 20P panel), that Zones 17 to 24 have a Zone Type (ZT) of '00'. If the zone expander was installed and active on Address 08, it would allow you to program Zones 17-24 as an Aux Wired Zones. The fact that you are also seeing Check 17.to Check 23 (24?) would also seem to tie to this a zone expander card. On the 4219/4229 module you would set Address 08 with the DIP Switches on the card itself.

If this module is not connected or having a problem, it would report as 108. Your first error 'Check 108 Wire Expansion' would suggest to me that there may have been a Zone Expander module (4219/4229) programmed as Address 08. Note that his happened to me when I disconnected a 4229 Zone Expander Module and didn't delete the Zones which were programmed on that module.

Honeywell alarm keypad wired zone professional#

CAVEAT.I'M NOT A PROFESSIONAL INSTALLER.JUST A HOMEOWNER WHO PROGRAMMED HIS OWN VISTA 20P CONTROL PANEL.SO USE THE ADVICE BELOW AT YOUR OWN RISK AS IT MAY NOT APPLY TO A HONEYWELL 21ip CONTROL PANEL.